19 Sep 2006, 12:16
I've got a P2 which refuses to be in working order for more than a month at a time. The latest failure (which ironically happened about two minutes after I gave it a THIRD new module) is that the backplate to the pusher has come loose from the watch case.
I've seen Azimuths instructions as to how to cure this and also those on Phil B's site but it just isn't working :(
I've taken the time screen out, I've got the case clamped, I'm using a butane torch and high quality solder but it just pops out again after a couple of pushes. It's not one of the cup style backplates like on a P3 but is just a copper rectangle.
Any help, hints, tips, ideas would be very much appreciated.