25 Feb 2016, 20:13
Okay,
First, resize your photos! Say 6 inches wide, use your photo app.
Second, remove the pushers, both reset and select pushers. They have o-rings and if good, you do not want to melt them. If hardened, Replace. Add silicone grease to the pusher assemblies after refinish in the case.
Three, remove the vinyl (clear plastic insulator) from inside the upper portion of the case (the ceiling), you can make a new one later.
Four, apply a hair dryer on high to the crystal from both sides. Heat it until it is too hot to touch. This will soften the epoxy. Remove. If it still stuck heat some more, both sides! Alcohol will dissolve and remaining epoxy from the case and crystal back.
Five, avoid the logo if you attempt to clean or polish the crystal.
Six, while working on the case I let the cleaned pushers and rear case gasket soak in silicone liquid. Get this from the car centre of your local car shop. Silicone spray for rubber gaskets and seals on door trims and etc for the car. Spray some in a small container and place the,pushers and case gasket in it.
Seven, lots of resized pictures!
Cheers.
Geoff