This old Microma is one the earlier models which has two recessed setting buttons on the side and no light. It had been working OK with all segments showing. Suddenly, on the second-from-right digit, the lower-right segment stopped showing. The 3rd photo shows an extra anomoly when the top-right of the segment disappeared too, but it comes back in the 5th photo. The 6th photo shows when the segment was OK. Penultimate photo shows the opened back of the watch with module visible. The module is not sitting loose (like later Microma models where you basically tip the case at a gentle angle and the module will drop out). There is some resistance when trying to pry it up (I stopped to avoid any accidental damage)
I did try to find existing posts on this but couldnt find anything that was helpful to this situation so apologies if this has already been covered and would be thankful for a pointer to the thread
I would appreciate if anyone has suggestions for diagnosing/fixing the problem and also to safely remove the module from the case.
Thanks a lot!
[url][/url]
[url][/url]
[url][/url]
[url][/url]
[url][/url]
[url][/url]
[url][/url]
[url][/url]
I did try to find existing posts on this but couldnt find anything that was helpful to this situation so apologies if this has already been covered and would be thankful for a pointer to the thread
I would appreciate if anyone has suggestions for diagnosing/fixing the problem and also to safely remove the module from the case.
Thanks a lot!
[url][/url]
[url][/url]
[url][/url]
[url][/url]
[url][/url]
[url][/url]
[url][/url]
[url][/url]