11 Oct 2009, 18:42
Renozumi,
charger105 is correct. The solder pad beside to the right of your #2 is the first contact for the display. For testing just solder the long legs of the display to the contacts. When it comes time to actually attach it, cut them down as small as possible, but leave enough to solder to the contacts. Look at board #6 to see how it was done from the factory.
Usually will solder the end contacts first for stability, then one in the center, and work my way out on either side from there. Also, you will have to make sure the display is not soldered on at an angle. It needs to be perpendicular to the board otherwise it won't fit into the Lexan top.